Products: 

EK-Supreme
EK-Supreme water block for CPU's has been designed for the hardest enthusiast user. The base plate is made of electrolytic copper lapped and polished to +/- 0,0007 mm flatness. The top is made of quality POM Acetal.
The EK-Wave cooling engine uses fine design. The water accelerates through thin jet plate channels through 49 very thin channels, which gives extreme cooling surface. The copper base is also very thin, which gives very short distance for temperature to transfer from CPU to water.
We recommend 1/2” (12mm) ID tubing or 3/8” (10mm) ID tubing.

Full Cover Blocks
The Full Cover blocks, such as Ek-FC8800 series, EK-FCR600, EK-FC86 and more has been designed for die hard enthusiast user. The main advantage is the RAM chips are also cooled so the ram heat sinks aren’t needed at all. Also the power regulator chips - Mosfets are cooled.
The Full Cover water blocks cooling engine uses also fin design. It uses waved channels. The curves increases cooling surface and turbulence. The turbulence in channels reduces thickness of laminar flow which significantly increases cooling performance compared to straight fins.
The additional aluminum part serves for cooling the power regulator chips, which needs better cooling if overclocked.
Thanks to the cooling engine the block doesn’t need high flow to perform well. The block has low pressure drop and performs well even at low flow.
We recommend 1/2" (12mm) ID tubing or 3/8" (10mm) ID tubing.

Chipset Water Blocks
The high performance low pressure drop water block was especially made for cooling chipset on NF4 motherboards, such as DFI nF4 SLI-DR, MSI K8N NEO4 Platinum, etc… The position of chipset cooler demands the unique low profile form of water block. Therefore the block does not interfere with graphic card in any PCIe slot, especially in SLI or Crossfire mode. The block has low pressure drop and has far better performance any Northbridge needs.
We recommend 1/2” (12mm) ID tubing or 3/8” (10mm) ID tubing.

Mosfet Water Blocks
Newest hi-end motherboards requires also mosfet's cooling. Ek Water Blocks have offered Mosfet blocks for most used motherboards. Plans for near future are to extend supported motherboards mosfet cooling. Blocks are designed to provide enough cooling and minimal water restriction.
We recommend 1/2" (12mm) ID tubing or 3/8" (10mm) ID tubing.

EK-Multioption reservoirs
New EK Multioption reservoirs, now in revision 2 offers a highest multioption position of incoming and outcomming tube connections. User can use each fitting/barb as inlet or outlet connection. Reservoirs are made of quality material. Tops and bottoms are made of POM Acetal material, the tube is made of quality acrilyc glass.
We recommend 1/2" (12mm) ID tubing or 3/8" (10mm) ID tubing.